Kintsugi Oxford
  • Home
  • REPAIR SERVICE
  • Shop & Booking
  • what's on
  • Kintsugi in Kyoto
  • What is kintsugi ?
  • Repairing a single break
  • Repairing a chip
  • Applying Urushi and Metalllic powder
  • Sealing, Polishing silver and gold finish
  • Filling in a missing piece
  • How to re-do.
  • Badly-damaged lamp to repair
  • Mugi Urushi
  • Kokuso
  • SABI
  • Shita-nuri, Naka nuri
  • How to repair leaking crack
  • How to use starter kit
  • Home
  • REPAIR SERVICE
  • Shop & Booking
  • what's on
  • Kintsugi in Kyoto
  • What is kintsugi ?
  • Repairing a single break
  • Repairing a chip
  • Applying Urushi and Metalllic powder
  • Sealing, Polishing silver and gold finish
  • Filling in a missing piece
  • How to re-do.
  • Badly-damaged lamp to repair
  • Mugi Urushi
  • Kokuso
  • SABI
  • Shita-nuri, Naka nuri
  • How to repair leaking crack
  • How to use starter kit

 
How to make and apply
​Urushi Putty
Kokuso

When your plate has a big part missing, you use Kokuso-Urushi as putty. 
YouTube Link:
Kintsugi, Kokuso, Urushi Filler.

You need
Kinoko(fine sawdust),  Rice glue , Ki-Urushi, Acetone
Tools
Disposable gloves,  A white plate or glass work surface, A spatula, Food wrap if you have,#1500-2000 wet and dry sandpaper, Box to keep your plate safe 


Kintsugi, Kokuso, Urushi Filler.

Picture
Preparation
When you use urushi, always wear disposable gloves.
 
Apply diluted Ki-urushi with gum turps (50:50), using cotton swab or brush on chips. Then place in Box. (Keep for a day in a box if you have time.) The photo is for preparation of Urushi Glue, but the work is the same.
Picture
Picture
Making Kokuso / Urushi putty
Make Nori-Urushi by mixing Ki-Urushi and rice glue, about the same amount each.  
 
Then mix sawdust into Nori-Urushi, this will become a hard urushi putty, called Kokuso. It’s consistency is like a soft clay. You can mix a little bit of Jino-ko (rougher powder than Tono-ko) to make harder putty. 

Picture
Picture
Apply the Kokuso on to the chipped area using spatula or a stick. Apply pressure to the area using your fingers. You can later cover the area with clingfilm and let the clingfilm hold the putty in place till it half hardens.
Place in a box about a week to allow Kokuso to set. 
 
Please remove the
clingfilm with in 24 hours.. 
Try not to apply more than 2 mm thickness of Kokuso. Ideally application is 1mm at time. If it is more than 2mm thickness, you’ll need to make  several applications a week apart.
When set, Kokuso’s surface will look rough.
Sand down Kokuso using sand paper with water till a smooth surface is achieved. Take care not to damage the surface of the item with sand paper.
Picture
Sealing, Polishing silver and gold finishIf you are happy, you can move to Sabi, fill the hole and rough surface with finer urushi putty, called Sabi. You can seal with diluted Ki-urush to harden Kokuso. Please refer to Sealing, Polishing silver and gold finish.
 
Proudly powered by Weebly